White 415 User's Guide download pdf (Page 21)

Solid, Dry-lined, Stud Partition or Dry Partition Wall Structures

1. Before you decide on the final position of

your shower control, please bear in mind

the following :

- Decide on a suitable position for

the shower control. The position

of the shower control and the

shower fittings must provide a

minimum gap of 25 mm between

the spill-over level of the shower

tray/bath and the handset. This is

to prevent backsiphonage.

- Determine whether the hot or cold

water services will be connected to

the shower control from the top

(falling) or from the bottom (rising).

2. Remove the plastic building-in shroud.

The two M5 x 50 mm building-in shroud

retaining screws should be screwed

temporarily into the base of the shower

control for use later.

3. Familiarise yourself with the hot and

cold water inlet ports and outlet port.

They can be identified as follows:

The Mira CombiForce 415B is supplied

with inlet connections hot left, cold

right and top outlet as standard.

To change the position of the outlet refer

to “Reversed Outlet Connection”:

instructions 1. to 8. inclusive.

4. Determine the route for the incoming hot

and cold water supply pipework. The

outlet pipework to a flexible shower fitting

is best positioned to emerge above and

to one side of the shower control to allow

the flexible hose to drape around the

underside of the shower preventing the

hose from interfering with the knob (refer

to diagram).

25 mm

Minimum

Spill-over Level

Hose Retaining

Ring

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

White 415 User's Guide Page 21

Comments to this Manuals

Related products and manuals for Sewing machines White 415